Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGhost Controls Gate Motor & Opener in Long Beach: What to Know First
We provide independent Ghost Controls gate motor and opener repair, replacement, and installation throughout Long Beach. Most Ghost Controls jobs are diagnosed the same day and finished within 24 to 48 hours once parts are in hand. Pricing is written down and handed to you before any work starts: a typical motor replacement runs $480 to $1,080 depending on the model, and a board-level repair usually lands between $185 and $340. If you own a Ghost Controls opener and it’s acting up, call us at (424) 788-1027. We’re independent of Ghost Controls (we are not an authorized Ghost Controls dealer), which means we fix the motor you have rather than steering you into a full system replacement.
How Ghost Controls Products Fail - and How We Fix Them
- AXDP series: arm drifts after a power cycle. The AXDP (the dual-swing arm kit Ghost Controls pairs with their heavy gates) relies on limit switches inside the arm body. In Long Beach, the salt-laden air off the ocean accelerates oxidation on those switch terminals. Symptom: the gate opens fine for weeks, then one morning it stops six inches short and the board blinks a fault. Fix: we pull the arm, clean and reseat the limit switch, and photograph the new position before we close it up.
- TSS1 and TDS1 openers: capacitor failure on older units. The start capacitor in the original TSS1 slide motor and TDS1 dual gate motor was undersized for heavy gates. When it fails, the motor hums but doesn’t move, and the homeowner usually assumes the motor is dead. A $35 capacitor and thirty minutes of labor usually fixes it. We test the cap with a meter before quoting the part.
- Ghost Controls remote receivers: interference from marine-band equipment. The 318 MHz receivers in Ghost Controls residential kits share spectrum with some older marine VHF and dock equipment. Long Beach homeowners near Alamitos Bay and the marinas report intermittent remote failure that comes and goes. Fix: we test signal strength at the board, relocate the antenna lead if it’s coiled, and if interference is chronic, we install a shielded receiver module rather than replacing the board.
- AXDP arm gear stripping on oversized gates. Ghost Controls rates the AXDP for gates up to 20 feet and 900 pounds, but a gate with a sagging hinge or a wind-catch panel puts more load on the nylon gear than the rating assumes. When the gear strips, the motor runs but the arm doesn’t travel. We replace the gear with an OEM part when the gate is within spec, but we also correct the underlying load issue (hinge, wheel, or track) so the repair isn’t repeated in eight months.
- Battery backup kits: charger failure, not battery failure. The Ghost Controls battery backup add-on uses a trickle charger module that sits outside the main board. When the charger fails, the battery drains in days and the gate goes dead during a power outage. We test the charger output under load before condemning a battery. This is a $120 to $180 repair, not a $300 battery replacement.
Our Ghost Controls Gate Motor & Opener Process
- 1
We pick up and talk through it. When you call (424) 788-1027, you get a live person. We ask about the symptom: motor hum, no response, intermittent open, fault light. We book the appointment and text you the technician’s name and photo before arrival.
- 2
We diagnose in writing. The first step on site is pulling the Ghost Controls cover and reading the fault code, then testing voltage at the board and motor terminals. We write down what we find before anyone picks up a tool.
- 3
We hand you the price. The written scope lists the part, the labor, and the total flat price. You approve it before any work begins. That’s Haven Standard Clause 1, and we don’t waive it.
- 4
We fix it with the right part. For warranty-sensitive failures (board, transformer), we use OEM Ghost Controls parts. For common wear items (capacitors, wire, brackets) we’re comfortable with quality aftermarket equivalents and will tell you which we’re installing and why.
- 5
We test, photograph, and document. We cycle the gate ten times, check the force settings and limit stops, adjust as needed, and photograph every reading. You get the photo log and a record of the part number installed before we leave.
- 6
We cover the work for a year. Every Ghost Controls repair carries the 365-Day Done Right Promise. If it isn’t right, we come back and make it right, no argument, no fee.
BeforeAfterWhat Ghost Controls Gate Motor & Opener Costs in Long Beach
| Job | Typical Range | What Moves the Price |
|---|---|---|
| Motor replacement (single swing or slide) | $480 - $1,080 | Model (TSS1 vs AXDP), gate weight, access to the pad |
| Board-level diagnosis and repair | $185 - $340 | Fault code, parts availability, board vs. capacitor vs. transformer |
| Battery backup charger replacement | $120 - $180 | Charger module only vs. battery also needed |
| Full opener installation (new Ghost Controls kit) | $1,200 - $2,300 | Single vs. dual gate, power run distance, existing hardware condition |
| Remote and receiver diagnostic | $95 - $175 | Interference source, receiver vs. remote failure |
Long Beach costs run slightly higher than inland because salt corrosion and marine humidity wear on motors faster, and we work with those conditions in every quote. The price we hand you is the price you pay. Free estimates on every Ghost Controls job: call (424) 788-1027.
Why Long Beach Homeowners Call Vance Gate Repair Long Beach for Ghost Controls Work
We’ve repaired enough Ghost Controls openers across Long Beach to know the brand’s habits: which fault codes mean what, which parts fail in this climate, and when a repair beats a replacement. But the bigger reason people call us back is what we leave behind. Every Vance visit ends with a photographed record of what was found, what was set, and what was installed. If the board was reading 7.2 volts at the motor terminal and you approved a transformer replacement, you get a photo of that reading and the new part number on paper. Adrian Vance built this habit on commercial access-control sites starting in 2014; he applies it to every residential Ghost Controls job. It means no future technician has to guess and no homeowner pays twice for the same diagnostic. We also service LiftMaster, Mighty Mule, and DoorKing, so if your gate was retrofitted or the motor turns out to be a different brand than the arm, we don’t walk away. 22,000+ gates repaired and installed since 2014, every one with a written price before the job started.
FAQs
No. Ghost Controls warranties their opener components against manufacturing defects, not against independent service. As an independent Ghost Controls service provider, we’re used to working on openers under warranty with OEM parts, and many Long Beach homeowners have us perform the labor while the part is covered. If the component itself is under warranty and fails, we’ll help you file the claim; we’ll provide the diagnostic record to support it.
Stock Ghost Controls boards, capacitors, arms, and remote kits are typically in our supplier’s hands within one to two business days. Common wear items (capacitors, wire harnesses, limit switches) are in our truck stock. If your part is backordered, we’ll tell you before we order, and you’ll have the price of the full repair in writing before any commitment. Call (424) 788-1027 for a free estimate and current part availability.
That depends on the specific failure and the age of the unit. A Ghost Controls opener with a failed capacitor, a worn gear, or a weak transformer is often repairable for well under half the cost of a new unit. A unit with a fried main board and a burned motor, or fifteen years of salt air on every terminal, may be closer to the replace threshold. If a new opener makes sense, we’ll say so, show you the number, and install whatever brand fits your gate and your budget. What we won’t do is lead with “replace it” before we’ve opened the cover and tested what’s underneath.
Yes. The Ghost Controls battery backup kit fits most residential openers in their current lineup, and we install it as an add-on service. In Long Beach, where power flickers during winter storms and coastal utilities run hot in summer, battery backup is the honest answer for anyone who can’t afford a dead gate. We’ll size the battery for your motor’s amp draw and explain the runtime you’re buying before any work starts.
If your Ghost Controls gate won’t open and you’re stuck behind it, call (424) 788-1027. We dispatch emergency calls the same day, which means if it’s a failed capacitor, a stripped gear, or a bad board, we may have the part on the truck. A live person answers the phone 24/7. Same-day dispatch is for real emergencies; standard Ghost Controls service calls are typically scheduled within a couple of days.
Here is what I found. Here is what it costs. Here is what I left behind. Call (424) 788-1027 for a free estimate on Ghost Controls gate motor and opener service anywhere in Long Beach.
Written by Adrian Vance, Owner, Vance Gate Repair Long Beach at Vance Gate Repair Long Beach, serving Long Beach and nearby areas.